upload
Baldor Electric Company
Industry: Electrical equipment
Number of terms: 4774
Number of blossaries: 0
Company Profile:
Usually refers to AC motors in 5,000 series frames and above and to 500 series frames and larger in DC.
Industry:Electrical equipment
The burden imposed on a motor by the driven machine. It is often stated as the torque required to overcome the resistance of the machine it drives. Sometimes "load" is synonymous with "required power."
Industry:Electrical equipment
Steady state current taken from the line with the rotor at standstill (at rated voltage and frequency). This is the current seen when starting the motor and load.
Industry:Electrical equipment
The minimum torque that a motor will develop at rest for all angular positions of the rotor (with rated voltage applied at rated frequency).
Industry:Electrical equipment
A motor converts electrical energy into a mechanical energy and in so doing, encounters losses. These losses are all the energy that is put into a motor and not transformed to usable power but are converted into heat causing the temperature of the windings and other motor parts to rise.
Industry:Electrical equipment
In order to reduce wear and avoid overheating certain motor components require lubricating (application of an oil or grease). The bearings are the major motor component requiring lubrication (as per manufacturer's instructions). Excess greasing can however damage the windings and internal switches, etc. (See PLS)
Industry:Electrical equipment
It is a fundamental principle of a winding that adjacent poles must be wound to give opposite magnetic polarity. This does not mean that the coils actually have to be wound in this direction before being placed into the stator. It does mean that the winding must be connected so that, if the current proceeds through one pole in a clockwise direction, it must proceed through the next pole in a counterclockwise direction. This principle is used to determine the correctness of connexion diagrams.
Industry:Electrical equipment
Motors in NEMA 143T to 449T frames.
Industry:Electrical equipment
A measure of an insulation system's resistance. This is usually measured in megohms and tested by passing a high voltage at low current through the motor windings and measuring the resistance of the various insulation systems.
Industry:Electrical equipment
A device that takes electrical energy and converts it into mechanical energy to turn a shaft.
Industry:Electrical equipment